top of page

185 SERIES DISC HARROW

Series 185 Flex Wing Tandem Disk Harrow - for use with tractors in the 200 – 400 hp range.

Features

  • Mainframe, wings, and gang carriers are constructed of tough, high-strength tubular steel for maximum strength and durability.

  • Weld on gang standards for optimum strength and rigidity assures precise gang alignment.

  • Hydraulically controlled transport assembly and wing fold-up.

  • Wing fold mechanism allows wings to float up and down 5° when disk plowing.

  • Equipped with oil bath dual tapered roller bearings.

  • Spring-loaded self-leveling hitch with a front-to-rear turnbuckle gives precise leveling control.

  • Fixed gang angle of 18° for both front and rear gangs.

  • Adjustable height on hitch clevis allows for straight-line pull and helps prevent gouging of the front gangs.

  • 9” (229mm) ground clearance with 24” (610mm) diameter disk blades.

  • 185lbs (84kg) of harrow weight per disk blade.

Specifications

*Engine horsepower is suggested ranges and varies according to soil conditions and weight added to the scraper.
NOTE: This scraper requires hydraulic control. One rear tractor hydraulic circuit required for scraper operation. Additional hydraulic circuits required for tilt option and each attachment.

Standart Equipment

Optional Equipment

  • 24” (610mm) diameter x 1/4” (6mm) thick, smooth (round) shallow concavity disk blades for longer life.

  • Tapered gang assemblies.

  • Disk-type balk buster.

  • Adjustable disk blade scrapers.

  • Heat-treated alloy steel gang axles.

  • Heavy-duty cast steel spacer spools.

  • Bearing wear plates.

  • Cylinder rod stops for positive depth control adjustment.

  • Hydraulic control group includes cylinders, hose holders, and hoses with fittings to reach the rear of the tractor.

  • Wheel hubs have 8-bolt, 6000lb (2722kg) slip-in spindles on the center frame and wings with two tapered roller bearings on each hub that are dust and moisture-protected.

  • Four dual sets of 12Lx15 farm highway service tires on center frames and wings for maximum floatation and tire capacity.

  • Transport locks pinwheels in the raised position for transport.

  • Two heavy-duty gang wrenches.

  • Drawbar jack stand.

  • 24” (610mm) diameter x 1/4” (6mm) thick, cutout (notched) front and smooth (round) rear shallow concavity disk blades.

  • 24” (610mm) diameter x 1/4” (6mm) thick, cutout (notched) front and rear shallow concavity disk blades.

  • Rear hitch assembly.

  • Rear hydraulic group.

  • Extra heavy-duty bearing wear plates with 1/4” (6mm) hard plate overlay.

  • Light group.

bottom of page